West Control Solutions 8700+ - Manual (Page 111)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
Page 106
P6010 & P8010 Model Group 59305, Issue 7 – March 2014
Table 27. P6010 & P8010 Set Up Mode Parameters
Parameter Legend
for 1 sec
followed
by
Set
Value
Adjustment Range &
Description
Default
Value When
Visible Units
Display
(
1
/
8
Din
Only)
Input Filter Time
constant  OFF, 0.5 to 100.0 seconds
in 0.5 sec increments
 .  Always

Process
Variable Offset 

Instrument Span  Always

Raw Process
Variable value  The un-scaled value of the input signal in mV, V or
mA DC as defined by the input range and type.
Resolution to 1 decimal place (e.g. 4.0 to 20.0mA).
This parameter is Read Only


= mV, V
or mA

blank
Process High
Alarm 1 value*  Range Min. to Range Max.
Repeat of Configuration Mode parameter
Range
Max.

=   if
alarm
1 only
or
Process Low
Alarm 1 value*  Range Min. to Range Max
Repeat of Configuration Mode parameter
Range
Min.

= 
Alarm 1
Hysteresis*  1 LSD to 100% of span (in display units)
on “safe” side of alarm point.
Repeat of Configuration Mode parameter  
is not
 
Process High
Alarm 2 value*  Range Min. to Range Max.
Repeat of Configuration Mode parameter
Range
Max.

=  
Process Low
Alarm 2 value*  Range Min. to Range Max.
Repeat of Configuration Mode parameter
Range
Min.

= 
Alarm 2
Hysteresis*  1 LSD to 100% of span (in display units)
on “safe” side of alarm point.
Repeat of Configuration Mode parameter  
is not
 
Process High
Alarm 3 value*  Range Min. to Range Max.
Repeat of Configuration Mode parameter Range
Max.

=  
Process Low
Alarm 3 value*  Range Min. to Range Max.
Repeat of Configuration Mode parameter
Range
Min.

= 
Alarm 3
Hysteresis*  1 LSD to 100% of span (in display units)
on “safe” side of alarm point.
Repeat of Configuration Mode parameter  
is not
 
Process High
Alarm 4 value*  Range Min. to Range Max.
Repeat of Configuration Mode parameter Range
Max.

=  
Process Low
Alarm 4 value*  Range Min. to Range Max.
Repeat of Configuration Mode parameter Range
Min.

= 
Alarm 4
Hysteresis*  1 LSD to 100% of span (in display units)
on “safe” side of alarm point.
Repeat of Configuration Mode parameter  
is not
 