West Control Solutions 8700+ - Manual (Page 82)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
59305, Issue 7
– March 2014 P6170, P8170 & P4170 Model Group Page 77
Upper
Display
Lower
Display
When Visible Description
SP Value  Display strategy 1, 3,
4, 5 and 6 if Digital
Input is not

in
config mode and
RSP is not used.
Target value of Setpoint.
Adjustable except in Strategy 6
SP1 Value 
or

Display strategies 1
to 6, if Digital Input is
set for dual SP
(

in config
mode).
Target value of Setpoint 1.

means
SP1 is selected as the active Setpoint.
Adjustable except in Strategy 6
SP2 Value 
or

Display strategies 1
to 6, if Digital Input is
set for dual SP
(

in config
mode).
Target value of Setpoint 2.

means
SP2 is selected as the active Setpoint.
Adjustable except in Strategy 6
Local Setpoint
Value 

or

If Remote Setpoint
Input is fitted and
Digital Input is not

in config
mode
Target value of Local Setpoint.

means the local setpoint is selected as the
active SP (if the digital input has been
overridden, the character is lit instead).
Adjustable except in Strategy 6
Remote
Setpoint
Value 

or

If Remote Setpoint
Input is fitted and
Digital Input is not

in config
mode
Target value of Remote Setpoint.

means the remote setpoint is selected as
the active SP (if the digital input has been
overridden, the character is lit instead).
Read only
Valve Position
Value xxx Display strategy 7 if
position indication
enabled ( or
 = ) The valve position as read by the Auxiliary
Input. Position is expressed as a
percentage from

(fully closed) to
 (fully opened).


or
  If Remote Setpoint
Input is fitted, Digital
Input is not

in
config mode and

is enabled in
Setup mode
Setpoint Select. Selects between Local or
Remote Setpoints.

= local SP,

= remote SP,

= selection via digital input (if configured).
Note:

or

will override the digital
input (active SP indication changes to )
Adjustable except in Strategy 6
Actual SP
Value  If a Ramping
Setpoint is in use
(

not Blank).
Actual value of selected Setpoint (e.g.
ramping SP value). Read only
SP Ramp
Rate Value  If

(ramping SP)
is enabled in Setup
mode.
Setpoint ramping rate, in units per hour.
Set to Blank (higher than ) to turn off
ramping. Adjustable except in Strategy 6