Brother MFC-795CW - Manual (Page 187)

Troubleshooting and Routine Maintenance
171
B
„ Call History
(Call ID history and Outgoing Call
history)
3 All Settings
You can reset all the machine settings
back to the settings that were set at the
factory.
Brother strongly recommends you use this
operation when you dispose of the
machine.
Note
Unplug the interface cable before you
choose Network or All Settings.
How to reset the machine
B
a
Press MENU.
b
Press a or b to display
Initial Setup.
c
Press Initial Setup.
d
Press a or b to display Reset.
e
Press Reset.
f
Press the reset function you want to use.
g
Press Yes.
h
Press Yes for 2 seconds to confirm to
reset.
Packing and shipping
the machine
B
When you transport the machine, use the
packing materials that came with your
machine. If you do not pack the machine
properly, you may void your warranty.
IMPORTANT
It is important to allow the machine to
‘park’ the print head after a print job. Listen
carefully to the machine before
unplugging it to make sure that all
mechanical noise has stopped. Not
allowing the machine to finish this parking
process may lead to print problems and
possible damage to the print head.
a
Open the ink cartridge cover.
b
Press the ink release lever to release
the ink cartridge and take out the ink
cartridges. (See Replacing the ink
cartridges on page 162.)
c
Install the green protective part and then
close the ink cartridge cover.