Brother MFC-795CW - Manual (Page 87)

Telephone Services and External devices
71
7
Using a non-Brother cordless
external telephone
7
If your non-Brother cordless telephone is
connected to the EXT. jack of the machine
and you typically carry the cordless handset
elsewhere, it is easier to answer calls during
the Ring Delay.
If you let the machine answer first, you will
have to go to the machine so you can press
Speaker Phone to send the call to the
cordless handset.
Using remote codes
7
Fax Receive code
7
If you answer a fax call on an extension or
external telephone, you can tell your machine
to receive it by dialing the Fax Receive Code
l
5 1. Wait for the chirping sounds then
replace the handset. (See Easy Receive
on page 48.)
If you answer a fax call at the machine’s
handset, you can make the machine receive
the fax by pressing Black Start and choosing
Receive.
If you answer a fax call at an external
telephone connected to the EXT. jack of the
machine, you can make the machine receive
the fax by pressing Speaker Phone, followed
by Black Start, and then pressing Receive.
Telephone Answer Code
7
If you receive a voice call and the machine is
in Fax/Tel mode, it will start to sound the F/T
Ring (a fast pseudo/double-ring) after the
initial ring delay. If you pick up the call on an
extension telephone you can turn the F/T
Ring off by pressing # 5 1 (make sure you
press this between the rings).
If the machine answers a voice call and
pseudo/double-rings for you to take over, you
can take the call at the machine's handset by
pressing Speaker Phone.
Changing the remote codes
7
The preset Fax Receive Code is l 5 1. The
preset Telephone Answer Code is # 5 1. If
you want to, you can replace them with your
own codes.
a
Press MENU.
b
Press a or b to display Fax.
c
Press Fax.
d
Press a or b to display
Setup Receive.
e
Press Setup Receive.
f
Press a or b to display Remote Codes.
g
Press Remote Codes.
h
Press On (or Off).
i
Do one of the following:
„ If you want to change the Fax
Receive Code, enter the new code.
Press OK, go to step j.
„ If you do not want to change the Fax
Receive Code, press OK, go to
step j.