HP Latex 3000 Printer - Manual (Page 265)

5. Reload the substrate and try to minimize skew while loading. Check that you are loading the substrate
using the correct procedure.
6. If you have experienced a substrate crash because the lateral edge of the substrate in the print zone is
not flat enough, and is raised or even partially cut because you are not using edge holders, then you are
recommended to use them.
NOTE: If you are already using edge holders, check that they are correctly positioned (see The
substrate edge holders on page 30 ).
7. Try reducing the drying power and curing temperature.
8. Start with the recommended configuration and increase vacuum and tensions step by step (i to iv),
following the table below.
TIP: If you have suffered a substrate crash, try starting with step iv and moving backwards up the
table until you find settings that work.
9. Try reducing the curing temperature and ink quantity, and raise the curing airflow to help in reducing
the substrate’s thermal contraction.
ENWW Printing issues 259