HP Latex 3000 Printer - Manual (Page 81)

* Non-porous textile or canvas. See Check the porosity of your substrate on page 23 .
Adjust the printing workflow for optimum color performance
1. Check your substrate's color calibration status and calibrate it if recommended, by selecting Substrate
> Color calibration in the Internal Print Server. See
Printer calibration on page 119 .
2. Create ICC profiles for your substrate; see your RIP documentation for instructions.
Remove a substrate preset
To remove a substrate preset from your printer, go to the Internal Print Server and select Substrate >
Remove. Then select the category and type of the substrate you wish to remove from a list of removable
substrates.
Set the carriage beam position
The carriage beam position determines the vertical distance between the printheads and the platen. If it is
too great, print quality will be impaired. If it is too small, there is a risk that the printheads will come into
contact with the substrate, causing smears or damage.
● The substrate-load position is not used for printing: it may be used for loading thick substrates or for
maintenance tasks.
● The printing position is a fixed height suitable for unwrinkled substrates up to 0.4 mm (0.016 in) thick.
● A custom position is used for substrates thicker than 0.4 mm (0.016 in), or for substrates that wrinkle
slightly due to heating. We recommend setting the custom position as follows:
◦ The thickness of the substrate plus 1.9 mm for substrates that do not wrinkle.
◦ The thickness of the substrate plus 2 to 3 mm for substrates that wrinkle.
You cannot exceed the maximum height permitted by the Internal Print Server.
ENWW Remove a substrate preset 75