HP Latex 3000 Printer - Manual (Page 56)

11. Go to the Internal Print Server and use the large blue button to advance the substrate until it reaches
the output spindle. Ensure that the substrate advances smoothly and is not trapped by any obstruction.
If necessary, help the substrate to advance and to pass through the curing module slot.
12. Open the loading table.
13. Align the substrate by checking that the substrate edge is in the same position on the input and output
spindles. This can be done by using the rulers on the spindles or by measuring the distance between the
right edge and the side plate.
14. When the substrate is evenly tensioned and flat (no wrinkles or bumps), attach it to the empty core with
adhesive tape. Tape it first in the center, and then at the left and right sides, making sure not to pull the
substrate excessively or leave it wrinkled.
15. If you are using them, place the substrate edge holders into position and attach them at the front.
16. Close the curing module and latches, then the front door.
17. If you are using them, attach the substrate edge holders at the rear.
18. Close the loading table and latches.
50 Chapter 3 Handle the substrate ENWW