HP Integrated Lights-Out 4 - Manual (Page 154)

When temperatures are displayed in Celsius, click the Show values in Fahrenheit button to change
the display to Fahrenheit. When temperatures are displayed in Fahrenheit, click the Show values
in Celsius button to change the display to Celsius.
By default, sensors that are not installed are hidden. To view the missing sensors, click show missing
sensors. When missing sensors are displayed, click hide missing sensors to hide them.
Figure 76 Viewing temperature sensor data
The Sensor Data table displays the following information:
•
Sensor—The ID of the temperature sensor.
•
Location—The area where the temperature is being measured.
In this column, Memory refers to the following:
◦ Temperature sensors located on physical memory DIMMs.
◦ Temperature sensors located close to the memory DIMMs, but not located on the DIMMs.
These sensors are located further down the airflow cooling path, near the DIMMs, to
provide additional temperature information.
The ID of the temperature sensor in the Sensor column helps to pinpoint the location, providing
detailed information about the DIMM or memory area.
•
X—The x-coordinate of the temperature sensor.
•
Y—The y-coordinate of the temperature sensor.
•
Status—The temperature status. Depending on the server configuration, some sensors show
a status of Not installed.
•
Reading—The temperature recorded by the listed temperature sensor. If a temperature sensor
is not installed, the Reading column shows the value N/A.
•
Thresholds—The temperature thresholds for the warning for overheating conditions. The two
threshold values are Caution and Critical. If a temperature sensor is not installed, the Thresholds
column shows the value N/A.
◦ Caution—The server is designed to maintain a temperature below the caution threshold
while operating. If a failure prevents the server from maintaining this temperature, the
154 Using iLO