HP Integrated Lights-Out 4 - Manual (Page 235)

The values displayed in the Current State table vary depending on the server type:
•
Present Power Reading—The current power reading from the server. This value is displayed
for all HP ProLiant server types.
•
Present Power Cap—The configured power cap for the server. This value is 0 if the power
cap is not configured. This value is displayed for HP ProLiant ML, DL, and blade servers.
•
Power Input Voltage—The supplied input voltage for the server. This value is displayed for HP
ProLiant ML and DL servers.
•
Power Regulator Mode—The configured HP Power Regulator for ProLiant mode. This value is
displayed for all HP ProLiant server types. For information about the possible settings, see
“Configuring power settings” (page 235) .
•
Power Supply Capacity—The server power capacity. This value is displayed for HP ProLiant
SL servers.
•
Peak Measured Power—The highest measured power reading. This value is displayed for HP
ProLiant SL servers.
Viewing the server power history
To view the server power history, navigate to the Power Management
→Power Meter page, as
shown in Figure 122 (page 233) . Scroll to the Power History section, as shown in Figure 123
(page 234) .
Figure 124 Power Meter page Power History section
The Power History table shows power readings from three time periods: 5 minutes, 20 minutes,
and 24 hours.
•
Average Power—The average of the power readings for the specified time period. If the server
has not been running for the specified time period, the value is the average of all readings
since the server booted.
•
Maximum Power—The maximum power reading from the server for the specified time period.
If the server has not been running for the specified time period, the value is the maximum of
all readings since the server booted.
•
Minimum Power—The minimum power reading from the server for the specified time period.
If the server has not been running for the specified time period, the value is the minimum of
all readings since the server booted.
Configuring power settings
The Power Settings page enables you to view and control the power management features of the
server. The power management features on this page vary based on the server configuration. You
must have the Configure iLO Settings privilege to change the values on this page.
Click the following link for a video demonstration of this feature: Using iLO Power Management .
For more HP iLO videos, see the HP iLO University Videos website at http://www.hp.com/go/
ilo/videos .
Using iLO Power Management 235