HP Integrated Lights-Out 4 - Manual (Page 56)

1. Navigate to the Administration
→Access Settings page, as shown in
Figure 25 (page 56)
Figure 25 Access Settings page
2. Update the following settings as needed:
Table 4 Service settings
Default value Service setting
Enables you to specify whether the SSH feature on iLO is enabled or
disabled. Secure Shell (SSH) Access
SSH provides encrypted access to the iLO CLP. The default is Enabled.
22 Secure Shell (SSH) Port
17990 Remote Console Port
80 Web Server Non-SSL Port (HTTP)
443 Web Server SSL Port (HTTPS)
17988 Virtual Media Port
Specifies whether iLO should respond to external SNMP requests. The
default setting is Enabled. SNMP Access
If you set SNMP Access to Disabled, the iLO Management Engine continues
to operate, and the information displayed in the iLO web interface is
updated, but no alerts are generated and SNMP access is not permitted.
When SNMP Access is set to Disabled, most of the boxes on the
Administration
→Management→SNMP Settings page are unavailable
and will not accept input.
The industry-standard (default) SNMP port is 161 for SNMP access. SNMP Port
If you customize the SNMP Port value, some SNMP clients might not work
correctly with iLO unless those clients support the use of a nonstandard
SNMP port.
The industry-standard (default) SNMP trap port is 162 for SNMP alerts
(or traps). SNMP Trap Port
56 Configuring iLO