HP Integrated Lights-Out 4 - Manual (Page 52)

1. Navigate to the iLO Federation
→Group Configuration page, as shown in
Figure 23 (page
52) .
Figure 23 Group Configuration page
2. Configure the following options in the Multicast Options section:
•
iLO Federation Management—Select Enabled or Disabled.
The default setting is Enabled. Selecting Disabled will disable the iLO Federation
Management features for the local iLO system.
•
Multicast Discovery—Select Enabled or Disabled.
Selecting Disabled will disable the iLO Federation Management features for the local iLO
system.
•
Multicast Announcement Interval (seconds)—Sets the frequency at which iLO announces
itself on the network. Select a value of 30 seconds to 30 minutes. The default value is 10
minutes.
Selecting Disabled will disable the iLO Federation Management features for the local iLO
system.
•
IPv6 Multicast Scope—Select the multicast discovery scope. The following values are
supported: Link, Site, and Organization.
IMPORTANT: Do not select the Global value. This value is not supported.
•
Multicast Time To Live (TTL)—Specifies the number of switches that can be traversed before
multicast discovery is stopped. The default value is 5.
3. Click Apply to save the settings.
IMPORTANT: To ensure that multicast discovery works correctly, make sure that all iLO systems
in the same group use the same values for Multicast Time to Live (TTL) and IPv6 Multicast Scope.
52 Configuring iLO