HP Integrated Lights-Out 4 User Manual
Page 97
When using IPv6, note the following:
•
IPv6 is not supported in the Shared Network Port configuration.
•
If you downgrade the iLO firmware from version 1.30 or later to version 1.2x, the IPv6 settings
will be reset to the default values.
To configure the IPv6 settings:
1.
Navigate to the Network
→iLO Dedicated Network Port page.
2.
Click the IPv6 tab, as shown in
Figure 43 IPv6 Settings page (iLO Dedicated Network Port)
3.
Configure the following settings:
•
iLO Client Applications use IPv6 first—When both IPv4 and IPv6 service addresses are
configured for iLO client applications, this option specifies which protocol iLO tries first
when accessing a client application. This setting also applies to lists of addresses received
from the name resolver when using FQDNs to configure NTP.
◦
Select this check box if you want iLO to use IPv6 first.
◦
Clear this check box if you want iLO to use IPv4 first.
Configuring iLO network settings
97