Load custom-size media into tray 2, 3, 4, or 5 – HP Color LaserJet CM6030CM6040 Multifunction Printer series User Manual
Page 123
●
SRA3 (Trays 3, 4, or 5 only)
●
B5 (ISO)
CAUTION:
Do not print envelopes or unsupported sizes of paper from the 500-sheet trays. Print on
these types of paper only from Tray 1. Do not overfill the input tray or open it while it is in use. Doing so
can cause paper jams.
Load custom-size media into tray 2, 3, 4, or 5
To use custom media, change the size setting on the control panel to
Custom
and set the unit of
measure, X dimension, and Y dimension. See
Configure a tray to match print job settings
1.
Slide open the tray from the product.
2.
Load the print media as described in steps 2 through 4 of the “Load detectable (standard-size)
media into Tray 2, 3, 4, or 5” section. Then proceed to step 3 in this procedure.
3.
Slide the tray into the product. The control panel shows the tray type and size configuration. To
specify specific custom dimensions, or if the type is not correct, touch
Modify
when the control
panel prompts to change the size or type.
Y
X
4.
Select
Custom
, and then select the
Unit of measure
,
X dimension
and
Y dimension
for the custom
paper size.
5.
Select the paper type and then touch
Save
.
6.
If the configuration is correct, touch
Save
.
ENWW
Load paper and print media 107