HP Color LaserJet CM6030CM6040 Multifunction Printer series - Manual (Page 292)

Solve common Macintosh problems
This section lists problems that can occur when using Mac OS X.
Table 15-1 Problems with Mac OS X
The printer driver is not listed in the Print Center or Printer Setup Utility.
Cause Solution
The product software might not have been installed or was installed
incorrectly. Make sure that the product PPD is in the following hard-drive folder:
Library/Printers/PPDs/Contents/Resources/
<lang>.lproj
, where <lang> is the two-letter language code for the language that
you are using. If necessary, reinstall the software. See the getting
started guide for instructions.
The Postscript Printer Description (PPD) file is corrupt. Delete the PPD file from the following hard-drive folder:
Library/Printers/PPDs/Contents/Resources/
<lang>.lproj
, where <lang> is the two-letter language code for the language that
you are using. Reinstall the software. See the getting started guide
for instructions.
The product name, IP address, or Rendezvous/Bonjour host name does not appear in the product list in the Print Center or Printer
Setup Utility.
Cause Solution
The product might not be ready. Make sure that the cables are connected correctly, the product is on,
and the ready light is on. If you are connecting through a USB or
Ethernet hub, try connecting directly to the computer or use a different
port.
The wrong connection type might be selected. Make sure that USB, IP Printing, or Rendezvous/Bonjour is selected,
depending on the type of connection that exists between the product
and the computer.
The wrong product name, IP address, or Rendezvous/Bonjour host
name is being used. Print a configuration page in order to check the product name, IP
address, or Rendezvous host name. Verify that the name, IP address,
or Rendezvous host name on the configuration page matches the
product name, IP address, or Rendezvous host name in the Print
Center or Printer Setup Utility.
The interface cable might be defective or of poor quality. Replace the interface cable. Make sure to use a high-quality cable.
The printer driver does not automatically set up your selected product in the Print Center or Printer Setup Utility.
Cause Solution
The product might not be ready. Make sure that the cables are connected correctly, the product is on,
and the ready light is on. If you are connecting through a USB or
Ethernet hub, try connecting directly to the computer or use a different
port.
The product software might not have been installed or was installed
incorrectly. Make sure that the product PPD is in the following hard-drive folder:
Library/Printers/PPDs/Contents/Resources/
<lang>.lproj
276 Chapter 15 Solve problems ENWW