Solve network connectivity problems, Solve network printing problems – HP Color LaserJet CM6030CM6040 Multifunction Printer series User Manual
Page 290
Solve network connectivity problems
If the product is having problems communicating with the network, use the information in this section to
resolve the problem.
Solve network printing problems
NOTE:
HP recommends that you use the product CD to install and set up the product on a network.
●
Make sure that the network cable is securely seated into the product's RJ45 connector.
●
Make sure that the Link LED on the formatter is lit. See
Understand lights on the formatter
●
Make sure that the I/O card is ready. Print a configuration page (see
). If an HP Jetdirect print server is installed, printing a configuration page also prints
a second page that shows the network settings and status.
NOTE:
The HP Jetdirect print server supports various network protocols (TCP/IP, IPX/SPX,
Novell NetWare, AppleTalk, and DCL/LLC). Make sure that the correct protocols and network
parameters are set correctly.
On the HP Jetdirect configuration page, verify the following items for your protocol:
◦
Under HP Jetdirect Configuration, the status is "I/O Card Ready."
◦
Protocol status is "Ready."
◦
An IP address is listed.
◦
The configuration method (Config by:) is listed correctly. See the network administrator if you
are not sure which method is correct.
●
Try printing the job from another computer.
●
To verify that a product works with a computer, use a USB cable to connect it directly to a computer.
You will have to reinstall the printing software. Print a document from a program that has printed
correctly in the past. If this works, a problem with the network might exist.
●
Contact your network administrator for assistance.
274 Chapter 15 Solve problems
ENWW