HP Color LaserJet CM6030CM6040 Multifunction Printer series - Manual (Page 223)

6. Reconnect the power cable and remaining interface cables, and turn the product on.
7. Print a configuration page. In addition to a product configuration page and a Supplies Status page,
an HP Jetdirect configuration page that contains network configuration and status information
should also print.
If it does not print, turn the power to the device off and uninstall and reinstall the print server card
to ensure that it is completely seated in the slot.
8. Perform one of these steps:
● Choose the correct port. See the computer or operating system documentation for
instructions.
● Reinstall the software, choosing the network installation this time.
Replace the staple cartridge
If the optional HP 3-bin Stapler/Stacker Accessory or HP Booklet Maker/Finisher Accessory runs out of
staples while it is stapling a print job, the product automatically stops, if set to stop when out. If the
product is set to continue when out, the product will continue to print without stapling.
NOTE: Only replace the staple cartridge unit when the stapler/stacker or booklet maker has run out
of staples. Removing the staple cartridge at other times can cause an error to occur.
NOTE: When the stapler/stacker or booklet maker runs out of staples, the stapler unit will return to its
default position automatically.
Replace the staple cartridge
1. Open the front door of the booklet maker or stapler/stacker.
ENWW Replace supplies 207