HP Color LaserJet CM6030CM6040 Multifunction Printer series - Manual (Page 124)

Load large size paper into Tray 3, 4, or 5
Use the following instructions if you are loading 11x17, RA3, SRA3, or 12 x 18-sized paper into Tray 3,
4, or 5.
1. Slide open Tray 3, 4, or 5.
2. Adjust the paper width guide by squeezing the adjustment latch and sliding the guide to the size
of the paper being used.
3. Load the paper into the tray.
4. Move the paper stop lever to the correct position for the paper being used.
● For SRA3-sized paper, rotate the lever all the way to the left.
● For A3- or 11x17-sized paper, rotate the lever down into the center position.
● For RA3- or 12x18-sized paper, rotate the lever all the way to the right.
5. Slide the tray into the product. The control panel shows the tray’s media type and size. If the
configuration is not correct, touch
Modify and configure the tray to the correct type and size. If the
configuration is correct, touch OK .
Load letterhead, pre-printed, or pre-punched paper
To correctly print or copy on letterhead, pre-printed, or pre-punched paper, you need to make sure you
load the paper correctly into the tray. You might also need to adjust the
Image Rotation setting on the
product control panel. The Image Rotation setting is used to adjust for languages that read from left to
right (the default) or from right to left.
108 Chapter 7 Paper and print media ENWW