Use manual print modes – HP Color LaserJet CM6030CM6040 Multifunction Printer series User Manual
Page 286
6.
Close the right door.
Use manual print modes
Try the following manual print modes to see if they solve the image quality problems. These options can
be found in the Optimize sub-menu under the control panel Print Quality menu. See
.
●
Fuser Temp: If you are seeing a faint image of the page repeated at the bottom of the page or on
the following page, you should first make sure the Paper Type and Print Mode settings are correct
for the type of paper you are using. If you continue to see ghost images on your print jobs, set the
Fuser Temp feature to one of the Alternate settings . Try the Alternate 1 setting first and see if it
solves the problem. If you continue to see the problem, try Alternate 2 and then Alternate 3. With
the Alternate 2 and Alternate 3 settings you may see an extra delay between jobs.
●
Light Media: Set this feature to On if you are frequently seeing Fuser Delay Jam or Fuser Wrap
Jam messages, especially when printing on light-weight paper or on jobs with heavy toner
coverage.
●
Media Temp: Set this feature to Reduced if you are having problems with paper sticking together
in the output bin.
●
Environment: Enable this feature if the product is operating in a low temperature environment and
you are having problems with print quality such as blisters in the printed image.
●
Line Voltage: Enable this feature if the product is operating in a low voltage environment and you
are having problems with print quality such as blisters in the printed image.
●
Background: Turn this feature on if pages are printing with a shaded background. Using this
feature can reduce gloss levels.
●
Paper Curl: Set this feature to Reduced if excessive curling of paper in the output bin occurs. This
setting will reduce printing speed and increase the frequency of consumable replacement.
●
Pre-rotation: Turn this feature on if horizontal streaks appear on pages. Using this feature
increases the warm-up time for the device.
●
Tray 1: If you are seeing marks on the back side of the paper or extra toner on pages when printing
from Tray 1, set the mode to Alternate. When the mode is set to Alternate a cleaning cycle will be
270 Chapter 15 Solve problems
ENWW