Logging in to the configuration interface, Configuring administrative users, Configuring a network connection – HP LeftHand P4000 SAN Solutions User Manual
Page 248
$ xterm
3.
In the xterm window, start minicom as follows:
$ minicom -c on -l NSM
Opening the Configuration Interface from the terminal emulation session
1.
Press Enter when the terminal emulation session is established.
2.
Enter start, and press Enter at the log in prompt.
3.
When the session is connected to the storage system, the Configuration Interface window
opens.
Logging in to the Configuration Interface
Once you have established a connection to the storage system, log in to the Configuration Interface.
Table 82 Logging in depends on where the storage system is
From Configuration Interface entry window
If the storage system is in
Press Enter to log in. The Configuration Interface main menu opens.
Available Systems pool
Management group
1.
Press Enter to log in.
2.
Enter the user name and password of the administrative user created for the
management group.
3.
Tab to Login, and press Enter.
NOTE:
This user is viewable in the CMC under the management group Administration category.
Configuring administrative users
Use the Configuration Interface to add new administrative users or to change administrative
passwords. You can only change the password for the administrative user that you used to log in
to the Configuration Interface.
1.
On the Configuration Interface main menu, press Tab to General Settings, and press Enter.
2.
To add an administrative user, Add Administrator, and press Enter. Then enter the new user’s
name and password. Confirm password, press Tab to select OK, and press Enter.
3.
To change the password for the user that you are currently logged in as, press Tab to select
Change Password, and press Enter. Then enter the new password. Confirm password, press
Tab to select OK, and press Enter.
4.
On the General window, press Tab to select Done, and press Enter.
Configuring a network connection
The storage system comes with two Ethernet interfaces.
lists where interfaces
are labeled and the label name.
Table 83 Identifying Ethernet interfaces on the storage system
Ethernet Interfaces
What the label says
Where labeled
Name:
TCP/IP Network configuration category
in the CMC
eth0, eth1
•
TCP/IP tab
Motherboard:Port0, Motherboard:Port1
G4-Motherboard:Port1, G4-Motherboard:Port2
•
TCP Status tab
248 Using the Configuration Interface