HP Photosmart D7460 Printer - Manual (Page 156)

Solution: Make sure your computer is turned on and is connected to the
HP Photosmart. Also make sure you installed the software that came with the
HP Photosmart.
For more information, see:
• “Communication problems over a USB connection” on page 113
• “Network troubleshooting” on page 125
Out of disk space
Cause: There is not enough available memory on your computer to perform the
task.
Solution: Close some applications and try the task again.
Card access error
Cause: There are two or more memory cards inserted into the HP Photosmart at
the same time.
Solution: Remove all but one memory card. The HP Photosmart reads the
remaining memory card and displays the first photo stored on the memory card.
Cause: You have inserted a Compact Flash memory card backwards or upside
down.
Solution: Remove the memory card and reinsert it correctly. The label of the
Compact Flash card faces up and should be readable as you insert it into the slot.
Cause: You have not fully inserted the memory card.
Solution: Remove the memory card and reinsert it in the memory card slot until it
stops.
Use only one card at a time
Cause: Multiple memory cards are inserted in the HP Photosmart.
Solution: You can insert only one memory card at a time.
If more than one memory card is inserted, the Attention light will blink rapidly, and an
error message will appear on the display. Remove the additional memory card to
resolve the problem.
Card is inserted incorrectly
Cause: The card is inserted backwards or upside down.
Solution: Turn the memory card so that the label side is up and the contacts are
facing the HP Photosmart, and then push the card forward into the appropriate slot
until the Photo light turns on.
Errors 155
Trou
bles
ho
ot
ing