HP Photosmart D7460 Printer - Manual (Page 47)

Parameter Description
Configuration
Source The protocol used to assign the IP address to the HP Photosmart:
• AutoIP: The installation software automatically determines the
configuration parameters.
• DHCP: The configuration parameters are supplied by a dynamic host
configuration protocol (DHCP) server on the network. On small networks,
this could be a router.
• Manual: The configuration parameters are set manually, such as a static
IP address.
• Not Specified: The mode used when the HP Photosmart is initializing.
DNS server The IP address of the domain name service (DNS) for the network. When you
use the web or send an e-mail message, you use a domain name to do it. For
example, the URL http://www.hp.com contains the domain name hp.com. The
DNS on the Internet translates the domain name into an IP address. Devices
use the IP addresses to refer to one another.
• IP Address: The IP address of the domain name server.
• Not Specified: The IP address is not specified, or the device is initializing.
NOTE: Check to see if a DNS IP address appears on the network
configuration page. If no address is shown, obtain the DNS IP address from
your Internet service provider (ISP).
Link
Configuration The speed at which data is transmitted over a network. Speeds include 10TX-
Full, 10TX-Half, 100TX-Full, and 100TX-Half. When set to None, networking
is disabled.
Total Packets
transmitted The number of packets transmitted by the HP Photosmart without error since
it has been turned on. The counter clears after the HP Photosmart is turned
off. When a message is transmitted over a packet-switching network, it is
broken up into packets. Each packet contains the destination address as well
as the data.
Total Packets
received The number of packets received by the HP Photosmart without error since it
has been turned on. The counter clears after the HP Photosmart is turned off.
Chapter 4
(continued)
46 Finish setting up the HP Photosmart
Finish set
up