HP Photosmart D7460 Printer - Manual (Page 28)

If you want to: See this section:
Add connections to more computers on the
network. “Connect to additional computers on a
network” on page 37
Change the HP Photosmart from a USB
connection to a network connection.
NOTE: Use the instructions in this section if
you first installed the HP Photosmart with a USB
connection, and you now want to change to
either a wireless or Ethernet network
connection.
“Change the HP Photosmart from a USB
connection to a network connection”
on page 38
View or change the network settings. “Manage your network settings” on page 38
Find troubleshooting information. “Network troubleshooting” on page 125
NOTE: You can connect the HP Photosmart to either a wireless or wired network,
but not both at the same time.
Wired network setup
This section describes how to connect the HP Photosmart to a router, switch, or hub using
an Ethernet cable and how to install the HP Photosmart software for a network
connection. This is known as a wired or Ethernet network.
To set up the HP Photosmart on a wired
network, you need to do the following: See this section:
First, collect all of the required materials. “What you need for a wired network”
on page 28
Next, connect to a wired network. “Connect the HP Photosmart to the network”
on page 28
Finally, install the software. “Install the software for a network connection”
on page 36
(continued)
Connect to a network 27
Finish
set
up