HP Designjet 9000s Printer series - Manual (Page 161)

Parameters:
● NORMAL — Normal fan suction level
● LOW — Low fan suction level
Initial temperature setting for the front heater (FRONT HEATER T)
Use this option to set the front heater temperature for the selected media type.
Parameters: 15 °C to 55 °C, or ** to turn the heater off.
NOTE For Celsius/Fahrenheit conversions:
F = (9 × C / 5) + 32
C = 5 × (F - 32) / 9
NOTE This value will only be applied if the HEATER PREF option is set to HEAT PANEL.
Initial temperature setting for the print heater (PRINT HEATER T)
Use this option to set the printer platen heater temperature for the selected media type.
Parameters: 15 °C to 55 °C, or ** to turn the heater off.
NOTE For Celsius/Fahrenheit conversions:
F = (9 × C / 5) + 32
C = 5 × (F - 32) / 9
NOTE This value will only be applied if the HEATER PREF option is set to HEAT PANEL.
Initial temperature setting for the rear heater (REAR HEATER T)
Use this option to set the rear heater temperature for the selected media type.
ENWW The MEDIA REG menu 151
Tell me about
f
ront
panel menus