HP Designjet 9000s Printer series - Manual (Page 21)

● Use only the electrical cord supplied by HP with the printer. Do not damage, cut, or repair the
power cord. A damaged power cord has risk of fire and electric shock. Replace a damaged power
cord with an HP-approved power cord.
● Do not allow metal or liquids (except those used in HP Cleaning Kits) to touch the internal parts of
the printer. Doing so may cause fire, electric shock, or other serious hazards.
● Power OFF the printer and unplug the power cable from the power outlet in any of the following
cases:
● When placing your hands inside the printer.
● If there is smoke or an unusual smell coming from the printer.
● If the printer is making an unusual noise not heard during normal operation.
● A piece of metal or a liquid (not part of cleaning and maintenance routines) touches internal
parts of the printer.
● During an electrical (thunder/lightning) storm.
● During a power failure.
● Inks used in the printer and liquids in the HP Cleaning kits contain an organic solvent (ethylene
glycol monobutyl ether acetate, CAS No. 112-07-2). Observe all local, state, and federal
regulations related to the handling, use, storage, and disposal of organic solvents.
● Ink and fluids used in the Cleaning Kits are combustible. Do not use or store within 8 meters (25
feet) of open flames, sparks, or other sources of ignition.
● Do not operate printer within 8 meters (25 feet) of open flames, sparks, or other sources of ignition.
Do not smoke within 8 meters (25 feet) of the printer.
● Install and operate the printer in a well-ventilated area.
● The printer installation must meet local, state, and federal regulations on the emissions of volatile
organic compounds in the workplace. It is the responsibility of the user to comply with these
regulations. HP recommends that installations use an ink vapor extraction and exhaust system or
an HP Air Purification System. Before installing a system exhausting ink vapors to the outside
atmosphere, consult with your local air quality control authorities. It is your responsibility to comply
with all local, state, and federal air pollution control regulations and building codes.
● Avoid contact between ink and skin, eyes, and clothing.
● Immediately wash skin with soapy water.
● Remove clothing soaked with ink from contact with skin.
● Use an approved eye wash station if ink is splashed into eyes and consult a doctor if
necessary.
If an approved eye wash station is unavailable, flush eyes with cold water and consult a
doctor if necessary.
● Do not swallow ink. If swallowed, do not induce vomiting, but seek immediate medical attention.
● Keep ink cartridges, cleaning kits, and waste ink bottles out of the reach of children.
● Be sure all operators are trained in the use of emergency equipment such as eye wash stations
and fire extinguishers and know where they are located.
ENWW Safety precautions 11
Int
roduct
ion