HP Designjet 9000s Printer series - Manual (Page 26)

Turn the power on/off
WARNING! Use the power supply voltage specified on the nameplate.
Be sure the printer is well-grounded. Failure to ground the printer may result in electrical
shock, fire, and susceptibility to electromagnetic interference.
CAUTION Always hold the power cord by the plug when connecting and disconnecting from
the power outlet. Never pull on the cord because this may damage it and create risk of fire and
electric shock.
Turn on the printer
1. Turn off (0) the printer switch on the left rear of the printer, and plug one end of the supplied power
cable into the socket of the printer. Insert the other power plug of the cable into an electrical outlet.
WARNING! Avoid overloading the printer’s electrical outlet with multiple devices. Use
only the electrical cord supplied by HP with the printer. Do not damage, cut, or repair the
power cord. A damaged power cord has risk of fire and electric shock. Replace a
damaged power cord with an HP-approved power cord.
1. Printer switch
2. Power socket
16 Chapter 2 How do I perform basic operations? ENWW
How do
I
perf
orm
basic
operat
ions?