Installation – ATEN PN9108U User Manual
Page 23
Installation
Before you Begin
Stacking
The PN9108U can be placed on any appropriate level surface that can safely
support its weight plus the weight of its attached cables. To place or stack the
PN9108U, remove the backing material from the bottom of the rubber feet
that came with this package, and stick them onto the switch’s bottom panel at
the corners, as shown in the diagram, below:
Note: To ensure adequate ventilation, allow at least 5.1 cm on each side, and
12.7cm at the back for power cord and cable clearance.
1. Important safety information regarding the placement of this
device is provided on p. iv. Please review it before proceeding.
2. Make sure that power to all the devices you will be connecting
up have been turned off. You must unplug the power cords of
any computers that have the Keyboard Power On function.
3. Make sure that the power supply voltage settings of all the
devices you will be connecting up match the voltage of the AC
source that the PN9108 is plugged into.
2005-09-07
Chapter 2 - Hardware Setup
9