ATEN PN9108U - Manual (Page 65)

Administrator Login Failure
If you are unable to perform an Administrator login (because the Username
and Password information has become corrupted, or you have forgotten it,
for example), you can clear the login information with the following
procedure:
1. Power off the PN9108U and remove its housing.
2. Short the jumper labeled J6.
3. Power on the switch.
4. When the Link and 10/100Mbps LEDs flash, power off the switch.
5. Remove the jumper cap from J6.
6. Close the housing and start the PN9108U back up.
After you start back up, you can use the default Username and Password
(see p. 15) to log in.
2005-09-07
Appendix
51