ATEN PN9108U - Manual (Page 52)

4. The wording for the System after AC back function may vary
somewhat from system to system. For example:
M AC Loss Auto Restart
M Restore on AC Power Loss
In the BIOS settings, choose Power On (Full On).
5. NT systems must use the System after AC back function.
Automated Setup
There are two methods to set up safe shutdown and rebooting: Automated,
and Manual. This section discusses an automated setup. Manual setup, is
discussed on page 40. Automated setup is made possible with the use of the
Power Monitor utility supplied on the software CD that came with this
package.
Note: Power Monitor only works with Windows systems.
Power Monitor watches the computer’s power status via the UPS signal. If
the UPS signals a power failure and a low battery condition, a dialog box
pops up to inform you that the utility will perform a safe shutdown in a few
seconds.
Installation
To install the Power Monitor, simply execute the self extracting setup
program (PMonitorSetup.exe). A copy of PMonitor.exe is placed in the
Windows Startup folder so that it executes each time the system is booted.
When monitoring is in effect, a monitoring icon in the form of lightning bolt
( ) is placed in the Windows taskbar to indicate so. When monitoring is
temporarily disabled, a canceled lightning bolt icon ( ) is displayed.
M You can switch between enabled and disabled by right clicking the icon
and selecting Start Monitor or Stop Monitor from the pop up context menu.
M You can exit the program by right clicking on the icon and selecting Exit
from the pop up context menu.
2005-09-07
PN9108U User Manual
38