HP LaserJet 4345 Multifunction Printer series - Manual (Page 200)

Jam message Procedure for clearing the jam
13.JJ.NT JAM INSIDE TOP COVER AREA See Clearing jams from the top-cover and print-
cartridge areas .
13.JJ.NT JAM INSIDE TRAY 2 AREA See Clearing jams from the tray 2, 3, 4, or 5 areas .
13.JJ.NT JAM INSIDE TRAY 2 RIGHT
ACCESS DOOR See Clearing jams from the tray 2, 3, 4, or 5 areas .
13.JJ.NT JAM INSIDE TOP COVER AREA See Clearing jams from the top-cover and print-
cartridge areas .
13.JJ.NT PAPER JAM OPEN INPUT TRAYS See Clearing jams from the tray 2, 3, 4, or 5 areas .
13.JJ.NT JAM IN STAPLER See Clearing staple jams .
When clearing jams, be very careful not to tear jammed media. If a small piece of media is
left in the MFP, it could cause additional jams. If jams are a recurring problem, see
Solving
repeated jams .
Note Loose toner might remain in the MFP after a jam and cause temporary print-quality
problems. These problems shoud clear up within a few pages.
Clearing jams from the top-cover and print-cartridge areas
Clear jams that occur during the printing process by using this procedure.
To clear jams from the top-cover and print-cartridge areas
1. Open the top cover and remove the print cartridge.
CAUTION To prevent damage to the print cartridge, do not expose it to light for more than a few
minutes. Cover the print cartridge with a sheet of paper while it is outside of the MFP.
2. Use the green handle to lift the paper-access plate.
Control-panel messages for jams (continued)
186 Chapter 10 Solving problems ENWW