HP LaserJet 4345 Multifunction Printer series - Manual (Page 219)

Control panel message Description Recommended action
13.JJ.NT JAM INSIDE TRAY 2
RIGHT ACCESS DOOR Media is jammed inside tray 2 in the jam-
access door. Follow the instructions in the onscreen
dialog box. See
Clearing jams from the
tray 2, 3, 4, or 5 areas .
13.JJ.NT JAMS INSIDE TOP
COVER AREA Remove print
cartridge Media is jammed in more than one
location inside the top cover area. You
must remove the print cartridge to clear
the jams. Follow the instructions in the onscreen
dialog box. See
Clearing jams from the
top-cover and print-cartridge areas .
13.JJ.NT PAPER JAM OPEN
INPUT TRAYS Media is jammed inside one or more of
the trays. Follow the instructions in the onscreen
dialog box. See
Clearing jams from the
tray 2, 3, 4, or 5 areas .
20 INSUFFICIENT MEMORY To
continue touch OK The MFP received more data than can fit
in the available memory. You might have
tried to transfer too many macros, soft
fonts, or complex graphics. Touch OK to print the transferred data
(some data might be lost), and then
simplify the print job or install additional
memory. See
Installing memory .
21 PAGE TOO COMPLEX To
continue touch OK The page formatting process was not
fast enough for the MFP. Touch OK to print the transferred data.
(Some data might be lost.) If this
message appears often, simplify the
print job.
22 EIO X BUFFER OVERFLOW To
continue touch OK Too much data was sent to the EIO card
in the specified slot (x). An incorrect
communications protocol might be in use. Touch OK to print the transferred data.
(Some data might be lost.)
Check the host configuration. If this
message persists, contact an HP-
authorized service or support provider.
(See the HP support flyer, or go to
http://www.hp.com/support/lj4345mfp .)
22 EMBEDDED I/O BUFFER
OVERFLOW To continue touch OK Too much data was sent to the
embedded HP Jetdirect print server. Touch OK to print the transferred data.
(Some data might be lost.)
22 PARALLEL I/O BUFFER
OVERFLOW To continue touch OK Too much data was sent to the parallel
port. Touch OK to clear the error message.
(Data will be lost.)
Check for a loose cable connection, and
be sure to use a high-quality cable.
Some non-HP parallel cables might be
missing pin connections or might
otherwise not conform to the IEEE-1284
specification. See
Part numbers , or go to
http://www.hp.com/support/lj4345mfp .
22 SERIAL I/O BUFFER
OVERFLOW To continue touch OK Too much data was sent to the serial
buffer. Touch OK to clear the error message.
(Data will be lost.)
30.1.YY SCANNER FAILURE An error has occurred in the scanner. Turn the MFP off and then on.
If this message persists, contact an HP-
authorized service or support provider.
(See the HP support flyer, or go to
http://www.hp.com/support/lj4345mfp .)
40 BAD EIO X TRANSMISSION To
continue touch OK The connection between the MFP and
the EIO card in the specified slot has
been broken. Touch OK to clear the error message
and continue printing.
Control-panel messages (continued)
ENWW Resolving control-panel messages 205