HP LaserJet 4345 Multifunction Printer series User Manual
Page 228
Control panel message
Description
Recommended action
Reattach output bin
The standard output bin was detached
when the MFP was turned on, or the
cable on the stapler/stacker or the 3-bin
mailbox is not connected to the MFP.
Turn the MFP off. If you are using the
stapler/stacker or the 3-bin mailbox,
make sure that the cable is connected to
the MFP. Reattach the output bin, and
then turn the MFP on. Observe the LED
on the output device. If it is flashing or
amber, see
lights for the 3-bin mailbox and stapler/
stacker
REINSERT DUPLEXER
The duplexer has been removed and
must be reinstalled.
Reinsert the duplexer in the MFP.
REINSTALL OUTPUT DEVICE
The output device has been removed or
is not attached.
Make sure the output bin, 3-bin mailbox,
or stapler/stacker is correctly installed on
the MFP.
REPLACE CARTRIDGE
The print cartridge has reached the end
of its life. Printing cannot continue.
Replace the print cartridge. To order a
new print cartridge, see
.
REPLACE STAPLE CARTRIDGE
The stapler is out of staples.
Replace the staple cartridge. For
information about replacing the staple
cartridge see
. For
information about ordering a new staple
cartridge, see
SANITIZING DISK <X>%
COMPLETE Do not power off
The hard disk or flash memory card is
being cleaned.
Contact the network administrator.
SCAN CARRIAGE LOCKED
Check lock switch, cycle power
The flatbed scanner carriage is locked
for shipping.
Turn off the MFP, unlock the scanner
carriage, and turn on the MFP.
SCAN FAILURE Press 'Start' to
rescan
The scan was unsuccessful and the
document needs to be rescanned.
If necessary, reposition the document to
rescan it, and then press
S
TART
.
SMTP GATEWAY
The SMTP gateway has exceeded a
time out value.
Verify the e-mail server address. See
. Contact the
network administrator.
STAPLER LOW ON STAPLES
Fewer than 20 staples remain in the
staple cartridge. Printing continues until
the cartridge runs out of staples and the
REPLACE STAPLE CARTRIDGE
message appears on the control-panel
display.
Replace the staple cartridge. For
information about replacing the staple
cartridge see
. For
information about ordering a new staple
cartridge, see
The Digital Sending Service at
<IP Address> does not service
this MFP. Contact administrator.
The MFP cannot communicate with the
specified IP address.
Verify the IP address. Contact the
network administrator.
The Digital Sending Service must
be upgraded to support this
version of the MFP firmware.
Contact administrator.
The Digital Sending Service is not
supported by the version of the firmware
that is currently installed for the MFP.
Check the firmware version. Contact the
network administrator.
The folder you have entered is
not a valid folder.
The folder name was entered incorrectly,
or the folder does not exist.
Re-enter the folder name correctly, or
add the folder.
TOO MANY PAGES IN JOB TO
STAPLE
The maximum number of sheets the
stapler can staple is 30.
For print jobs that have more than 30
pages, staple them manually.
Control-panel messages (continued)
214
Chapter 10 Solving problems
ENWW