HP LaserJet 4345 Multifunction Printer series - Manual (Page 296)

Checking memory installation
After installing the DIMM or flash memory card, make sure that the installation was
successful.
To verify that memory devices are installed correctly
1. Check that Ready appears on the control-panel display when the MFP power is turned
on. If an error message appears, a memory device might have been incorrectly installed.
See
Understanding MFP messages .
2. Print a new configuration page. (See Checking the MFP configuration .)
3. Check the memory section on the configuration page and compare it to the configuration
page that was printed before the memory installation. If the amount of memory has not
increased, the DIMM or flash memory card might not be installed correctly, or the DIMM
or flash memory card might be defective. Repeat the installation procedure. If
necessary, install a different DIMM or flash memory card.
Note If you installed a printer language (personality), check the "Installed Personalities and
Options" section on the configuration page. This area should list the new printer language.
282 Appendix E MFP memory and expansion ENWW