HP LaserJet 4345 Multifunction Printer series - Manual (Page 278)

Labels
CAUTION To avoid damaging the MFP, use only labels recommended for laser printers. Never print on
the same sheet of labels more than once or print on a partial sheet of labels.
Label construction
When selecting labels, consider the quality of each component:
● Adhesives: The adhesive material should be stable at 200°C (392°F), the printer's
fusing temperature.
● Arrangement: Only use labels with no exposed backing between them. Labels can peel
off sheets with spaces between the labels, causing serious jams.
● Curl: Prior to printing, labels must lie flat with no more than 13 mm (0.5 inch) of curl in
any direction.
● Condition: Do not use labels with wrinkles, bubbles, or other indications of separation.
For more information, see Printing on labels .
Note Choose labels in the printer driver (see Using the printer drivers ).
Transparencies
Transparencies used in the printer must be able to withstand 200°C (392°F), the printer's
fusing temperature.
CAUTION To avoid damaging the MFP, use only transparencies recommended for use in HP LaserJet
printers, such as HP-brand transparencies. (For ordering information, see
Part numbers .)
For more information, see Printing on transparencies .
Note Choose transparencies in the printer driver (see Using the printer drivers ).
264 Appendix D Media specifications ENWW