Allied Telesis AT-IFS802SP/POE - Manual (Page 36)

32 AT-IFS802SP/POE(W)-80 User Manual
Backup Configuration interface
You can back up the current configuration from flash ROM to the TFTP server for the purpose of
recovering the configuration later. It helps you to avoid wasting time on configuring the settings by
backing up the configuration.
TFTP Server IP Address • : Type in the TFTP server IP.
Backup File Name • : Type in the file name.
Click •
6.7.3 Backup Configuration
Apply
6.8 System Event Log
This page allows the user to decide whether to send the system event log, and select the mode which
the system event log will be sent to client only, server only, or both client and server. What kind of
event log will be issued to the client/server depends on the selection on the
Event Configuration
tab. There are five types of event—Device Cold Start, Device Warm Start, Authentication Failure,
X-Ring Topology Change, and Port Event—available to be issued as the event log.
Syslog Client Mode • : Select the system log mode—Client Only, Server Only, or Both. ‘Client
Only’ means the system event log will only be sent to this interface of the switch, but on the other
hand ‘Server Only’ means the system log will only be sent to the remote system log server with
its IP assigned. If the mode is set in ‘Both’, the system event log will be sent to the remote server
and this interface.
System Log Server IP Address
• : When the ‘Syslog Mode’ item is set as Server Only/Both, the
user has to assign the system log server IP address to which the log will be sent.
Click to refresh the event log displaying area.
•
Click to clear all the current event logs. •
Make sure the selected mode is correct, and click to have the setting take effect. •
6.8.1 Syslog Configuration
Reload
Clear
Apply