Allied Telesis AT-IFS802SP/POE - Manual (Page 85)

81 AT-IFS802SP/POE(W)-80 User Manual
Port Commands Set
Allied Telesis Commands Level Description Example
interface fastEthernet
[Portid]
G
Choose the port for
modification.
switch(config)#interface fastEthernet 2
duplex [full | half] I
Use the duplex
configuration command to
specify the duplex mode of
operation for Fast Ethernet.
switch(config)#interface fastEthernet 2
switch(config-if)#duplex full
Speed
[10|100|1000|auto]
I
Use the speed
configuration command to
specify the speed mode of
operation for Fast Ethernet.,
the speed can’t be set to
1000 if the port isn’t a giga
port..
switch(config)#interface fastEthernet 2
switch(config-if)#speed 100
no flowcontrol I
Disable flow control of
interface
switch(config-if)#no flowcontrol
security enable I Enable security of interface switch(config)#interface fastEthernet 2
switch(config-if)#security enable
no security I Disable security of interface
switch(config)#interface fastEthernet 2
switch(config-if)#no security
bandwidth type all I
Set interface ingress limit
frame type to “accept all
frame”
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type all
bandwidth type
broadcast-multicast-
flooded-unicast
I
Set interface ingress limit
frame type to “accept
broadcast, multicast, and
flooded unicast frame”
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type
broadcast-multicast-flooded-unicast
bandwidth type
broadcast-multicast
I
Set interface ingress limit
frame type to “accept
broadcast and multicast
frame” switch(config)#interface
fastEthernet 2
switch(config-if)#bandwidth type
broadcast-multicast
bandwidth type
broadcast-only
I
Set interface ingress limit
frame type to “only accept
broadcast frame” switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type
broadcast-only
bandwidth in [Value] I
Set interface input
bandwidth. Rate Range is
from 100 kbps to 102400
kbps or to 256000 kbps for
giga ports, and zero means
no limit.
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth in 100