Allied Telesis AT-IFS802SP/POE - Manual (Page 51)

47 AT-IFS802SP/POE(W)-80 User Manual
Having set up the LACP aggregator on the tab of Aggregator Setting, you can configure the state
activity for the members of the LACP trunk group. You can tick or cancel the checkbox beside
the state label. When you remove the tick mark of the port and click , the port state
activity will change to
Passive.
Active • : The port automatically sends LACP protocol packets.
Passive • : The port does not automatically send LACP protocol packets, and responds only if
it receives LACP protocol packets from the opposite device.
6.15.3 State Activity
Apply
[note]
A link having two passive LACP nodes will not perform dynamic LACP trunk
because both ports are waiting for an LACP protocol packet from the opposite
device.
State Activity of Switch 1
State Activity of Switch 2