Allied Telesis AT-IFS802SP/POE - Manual (Page 45)

41 AT-IFS802SP/POE(W)-80 User Manual
Port Statistics interface
6.14 Port Control
In Port control you can configure the settings of each port to control the connection parameters, and
the status of each port is listed beneath.
Port • : Use the scroll bar and click on the port number to choose the port to be configured.
State • : Current port state. The port can be set to disable or enable mode. If the port state is set
as ‘Disable’, it will not receive or transmit any packet.
Negotiation
• : Auto and Force. Being set as Auto, the speed and duplex mode are negotiated
automatically. When you set it as Force, you have to set the speed and duplex mode manually.
Speed
• : It is available for selecting when the Negotiation column is set as Force. When the
Negotiation column is set as Auto, this column is read-only.
Duplex
• : It is available for selecting when the Negotiation column is set as Force. When the
Negotiation column is set as Auto, this column is read-only.
Flow Control
• : Whether or not the receiving node sends feedback to the sending node is
determined by this item. When enabled, once the device exceeds the input data rate of another
device, the receiving device will send a PAUSE frame which halts the transmission of the sender
for a specified period of time. When disabled, the receiving device will drop the packet if too much
to process.
Security
• : When the Security selection is set as ‘On’, any access from the device which connects
to this port will be blocked unless the MAC address of the device is included in the static MAC
address table. See the segment of
MAC Address Table—Static MAC Addresses.
Click to have the configuration take effect. •
Apply