A&D Digital Platform Scales HW-10KGV - Manual (Page 32)

HW-G Instruction Manual Page 30
HW-G OZIM v1a
Step 6 If one of f6 0 , f6 2 , f6 4 , f6 6 has
been selected, press the SET switch to
use the comparator.
Step 7 Press the MODE switch to display the
HI, blinking.
Step 8 Set the upper limit value by using the
following switches.
^ switch Selecting the value of a digit.
< switch Selecting a digit.
F switch Selecting the polarity (+,-).
Step 9 Press the ENTER switch to store the new
parameter and display the blinking LO.
Step 10 Set the lower limit value by using the
following switches.
^ switch Selecting the value of a digit.
< switch Selecting a digit.
F switch Selecting the polarity (+,-).
Step 11 Press the ENTER switch to store the
new parameters and display the
weighing mode.