A&D Digital Platform Scales HW-10KGV - Manual (Page 40)

HW-G Instruction Manual Page 38
HW-G OZIM v1a
Step 6 Press the MODE switch to display the
HI, blinking. (Final value).
Step 7 Set the final value using the following switches.
^ switch Selecting the value of a digit.
< switch Selecting a digit.
Step 8 Press the ENTER switch to store the new
parameter and display the OK, blinking,
(Preliminary value).
Step 9 Set the preliminary value using the following
switches.
^ switch Selecting the value of a digit.
< switch Selecting a digit.
Step 10 Press the ENTER switch to store the new
parameter and display the LO, blinking, (Zero
band).
Step 11 Set the zero band using the following switches.
^ switch Selecting the value of a digit
< switch Selecting a digit.
Step 12 Press the ENTER switch to store the new
parameter and display the weighing mode.
13.2 Operation and Performance (Examples)
Step 1 Select the parameter f6 8 of the function table.
Step 2 Set the parameters of the final value, preliminary value and zero band.
Step 3 The comparison result is always displayed.