Aastra Telecom 9480i Series - Manual (Page 287)

Global SIP Settings
41-001160-03, Rev 00, Releaes 2.4 4-105
Configuring Network and Session Initiation Protocol (SIP) Features
Configuring Autodial Using the Aastra Web UI
Use the following procedure to configure Autodial using the Aastra Web UI.
By default, your IP phone uses the global settings you specify for Autodial for all
lines on your IP phone. However, you can also configure Autodial on a per-line
basis.
Aastra Web UI
Global Configuration
1 Click on Advanced Settings->Global SIP->Autodial Settings.
2 In the “Autodial Number” field, specify the SIP number that the IP phone dials whenever the IP
phone is off-hook. An empty (blank) value disables autodial on the phone.
For example: 8500
3 In the “Autodial Timeout” field, specify a value, in seconds, for the timer as follows:
• If you want the IP phone to autodial the number immediately (hotline) whenever the IP phone is
off-hook, accept the default value of 0.
• If you want to specify a length of time for the IP phone to wait before dialing the number, enter
the length of time (in seconds). For example: 30
Valid values are 0 to 120.
4 Click to save your changes.
Draft 1