Switch focus to ringing line, Configuring “switch focus to ringing line, Switch focus to ringing line -79 – Aastra Telecom 9480i Series User Manual
Page 377: Feature, see, Switch, Focus to ringing line, Draft 1
Operational Features
41-001160-03, Rev 00, Releaes 2.4
5-79
Configuring Operational Features
Switch Focus to Ringing Line
An Administrator or User can control the behavior of the phone when it receives
an incoming call when it is already in a connected call. By default, the phone
switches focus to the ringing line to enable the user to see who is calling them.
You can turn off this functionality so that the phone now stays focused on the
connected call.
You can do this using the “switch focus to ringing line”
parameter in the configuration files or the Aastra Web UI.
Configuring “Switch Focus to Ringing Line”
You use the following procedures to enable or disable “Switch Focus to Ringing
Line”.
Note:
If you configure the BLF/Xfer key(s) and/or Speeddial/Xfer
key(s) on the phone, you can enable or disable the switching of the
user interface focus to ringing line while the phone is in the connected
state.
Configuration Files
For specific parameters you can set in the configuration files for enabling disabling “Switch Focus to Ringing
Line”, see Appendix A, the section,
“Switch Focus to Ringing Line”
on
Draft 1