Aastra Telecom 9480i Series - Manual (Page 411)

Operational Features
41-001160-03, Rev 00, Releaes 2.4 5-113
Configuring Operational Features
Key Mapping
There are hard keys on your phone, such as Hold, Redial, Xfer, and Conf that are
configured by default for specific call-handling features. (See the product-specific
User Guide for more information about these key functions.
Enabling/Disabling Redial, Xfer, and Conf Keys
You can enable or disable the Redial, Xfer, and Conf keys as required using the
following parameters in the configuration files:
• redial disabled
• conference disabled
• call transfer disabled
Valid values for this parameter are 0 (enabled) and 1 (disabled).
If this parameter is set to 1, the key is not active and is ignored if pressed by the
user. For "redial disabled" the value of 1 does not save the dialed number to the
"Redial List".
If this parameter is set to 0, the key is active and can be pressed by the user.
This feature is configurable via the configuration files only.
Notes:
1. On the 9480i, 9480i CT, 6755i, 6757i, and 6757i CT the Xfer and
Conf
keys are hard-coded by default on keys 5 and 6 to the left of the
LCD display and cannot be reassigned. The Xfer and Conf labels
display when you lift the handset. To disable these keys, see the
next paragraph.
2. On the 9143i, 6751i, and 6753i, the Xfer and Conf keys are
assigned by
default to keys 5 and 6, respectively. These keys are programmable
keys and can be reassigned if applicable. To disable these keys, see
the next paragraph.
Draft 1