Lyntec RPCM - Manual (Page 32)

139-0498-01.32
Appendix C
32
Appendix C--RPC System
Components The LynTec system consists of control buses, a panelboard,
remotely operated circuit breakers, a power supply, an optional
buff er, a transducer and a controller.
Control Bus
Figure C-1
The control buses provide control and data monitoring for
remotely operated circuit breakers and are connected to the
power supply and controller. Installed control buses will not
interfere with the installation of standard circuit breakers into
the panelboard.
Remotely Operated Circuit Breakers provide the same
overcurrent protection as standard circuit breakers, and have an
integral operator that can remotely switch the circuit breaker
ON and OFF. The circuit breaker works with the RPC controller,
power supply, and control buses to provide a remote power
switching system in a panelboard. Remotely Operated
Circuit Breakers
Part Numbers:
MBR-15
MBR-20
MBR-30 Part Numbers:
MBR-215
MBR-220
MBR-230 Part Numbers:
MBR-315
MBR-320
MBR-330
Figure C-2