Lyntec RPCM - Manual (Page 8)

139-0498-01.8
Chapter Three--Quick Start Guide
8
Steps Reference
1. Connect the RPCM to 120/208V power source See appropriate instruction bulletins.
Chapter 4--Wiring
2. Make required control and/or network
connections See appropriate instruction bulletins.
3. Connect the controller to a computer or
network for panel setup. Chapter 4--Wiring
4. Access the web page by entering the IP address
or NetBIOS name into web browser. Chapter 5--Control Setup
5. Complete the panel setup. Chapter 5--Control Setup
Chapter Three--Quick Start Guide
INTRODUCTION This chapter is a quick reference listing the steps necessary to
install the RPCM. The steps in this chapter are provided as an
installation checklist. For complete installation instructions, refer
the chapter listed.