Class1 FoamLogix 2.1A & 1.7AHP REV D - Manual (Page 88)

FoamLogix, Model 2.1A and 1.7AHP Class “A”
Electronic Foam Proportioning Systems
88
Reference
The preceding foam concentrates have been tested by Hale Products in a Hale FoamLogix® system to
ensure compatibility with Hale FoamLogix® models 2.1A, 1.7AHP, 3.3 and 5.0 Foam Proportioning Systems.
These Chemicals were ran for several hundred hours over several months under nominal conditions
to make sure they do not harm the Foam System. This list is solely intended to assist the end user in
selection of foam concentrate(s) compatible with a Hale FoamLogix® Model 5.0 and 3.3 and is not a
determination of the fire fighting effectiveness of one product over another.
Always consult with NFPA standards, U.L. Listings, Federal, State, and local regulations, and requirements
pertaining to application and environmental regulations before selecting a foam concentrate. Some of the foam
chemicals listed may require special hardware considerations. (Refer to FoamLogix® user manual
for additional information).
Many Fire Fighting Foam Chemical Manufacturers have specific instructions on handling and use of their prod-
ucts including, but not limited to, shelf life, tank life, temperature limits, and intervals between use. Always
follow Manufacturers instructions for use.
This Appendix applies to Hale Foamlogix® foam pumps built after April 17, 1997. For Hale
FoamMaster foam pumps built prior April 17, 1997 refer to Bulletin 650, Rev 2.
If a particular foam concentrate you wish to use does not appear on this list, please contact your Hale
representative for information concerning compatibility with Hale FoamLogix® Foam Proportioning System.
As further testing is completed, Hale Products Inc. updates this list and expands capabilities and features to
keep the Hale FoamLogix® the best system available for all the fires you fight.