SkyTrak 6042 Operation Manual - Manual (Page 114)

112 Model 6042 Origin 5/02
General Maintenance
Lubricate the following grease
fittings using
Multi-Purpose Grease (MPG)
every 50 hours:
A. Carriage pivot pins.......................................... (2 points)
B. Attachment tilt cylinder pins .......................... (2 points)
C. Boom attachments .......................................... (all points)
D. Extend Chain Sheave...................................... (1 point)
E. Retract Chain Sheave ..................................... (1 point)
Lubricate the following grease
fittings using
Multi-Purpose Grease (MPG)
every 250 hours:
F. Hydraulic cylinder pins................................... (12 points)
G. Drive shaft slip joints ...................................... (3 points)
H. Boom pivot pin ................................................ (2 points)
I. Axle U-Joints ................................................... (8 points)
J. Axle pivot pins................................................. (4 points)
Lubricate the following grease
fittings using
Multi-Purpose Grease (MPG)
every 1000 hours:
K. Extend cylinder pins ....................................... (2 points)
NOTE: Shorten the lubrication interval on all lube points when operating in
severe conditions.
1. Lubrication Points
OS1750
50
OH2680
250
OH2710
OS1750
1000
OH2690
OS1750