SkyTrak 6042 Operation Manual - Manual (Page 5)

Safety Practices
3 Model 6042 Origin 5/02
Safety Practices
OmniQuip reserves the right to make changes on and to add
improvements upon its products at any time without public notice or
obligation. OmniQuip also reserves the right to discontinue manufacturing
any product at its discretion at any time.
NOTICE: Under OSHA rules, it is the responsibility of the employer to
provide operator training. Successful completion and certification of Safety
Training for Rough Terrain Forklifts is required. Operator Training Kits are
available by calling Ken Cook Company at (414) 466-6060. An order form
for these kits is available through our website,
http://www.omniquip.com.
The information in this manual does not replace any safety rules and laws
used in your area. Before operating this vehicle, learn the rules and laws for
your area. Make sure the vehicle has the correct equipment according to
these rules and laws.
Your safety and the safety of others in the worksite depend significantly
upon your knowlege and understanding of all correct operating practices
and procedures for this vehicle.
This safety alert symbol is used with the following signal words to attract
your attention to messages found within the manual and on hazard decals
located on the vehicle. They are reproduced herein and pertain to proper
operation and procedure messages contained throughout the manual. The
message that follows the symbol contains important information about
Safety. To avoid possible death or serious personal injury, carefully read and
follow the messages! Be sure to fully understand the potential causes of
death or injury.
Disclaimer
WARNING:
DO NOT modify or alter (weld, drill, etc.) any
part of this vehicle without consulting OmniQuip. Modifications
can weaken the structure creating a hazard that can cause death
or serious personal injury.
Hazard Classification System
OP0330