SkyTrak 6042 Operation Manual - Manual (Page 57)

Operation
55 Model 6042 Origin 5/02
1. Enter the cab using the hand holds and adjust the seat for comfort-
able operation.
2. Adjust the mirrors to obtain the best rear view from the operator’s
position.
3. Fasten the seat belt.
4. Make sure the parking brake switch is ENGAGED.
5. Place the travel select lever in (N) NEUTRAL and move the neutral
lock lever to NEUTRAL LOCK position.
6. Turn the ignition switch to the START position (fully clockwise) to
crank the engine. Release the key when the engine starts. If the
engine fails to start on the first try, wait until the engine and starter
come to a complete stop before cranking the engine again.
IMPORTANT! DO NOT crank the starting motor continuously for more than
30 seconds. Stop cranking the starter and allow the starter to cool for 2
minutes before engaging the starter again.
7. After the engine starts, run engine at partial throttle for 30 to 60 sec-
onds before operating the vehicle. Return to idle before engaging
the travel or range select lever.
8. Move the Neutral Lock Lever to the (D) DRIVE position before you
start operating.
9. Disengage the parking brake switch before you start operating.
Normal Starting
WARNING:
DO NOT start the engine unless you are in the
seat with the seat belt fastened around you. Death or serious per-
sonal injury could result if the belt is not securely fastened.