SkyTrak 6042 Operation Manual - Manual (Page 77)

Operation
75 Model 6042 Origin 5/02
Attachment Reconnect
Be sure you are performing this procedure on level ground.
1. Position the vehicle directly behind the attachment to be mounted.
2. Tilt the quick attach backward.
3. Extend the boom approximately 10 feet (3 meters) and drive the
vehicle forward until the attachment pivot pins are below and
between the two hooks on the attachment.
4. Raise the boom until the attachment pivot pins have seated fully in
the hooks of the attachment.
5. Tilt the attachment up slightly. The quick attach link should be tight
against the rear of the attachment and the holes in the link and the
attachment should be aligned.
6. Place the travel select lever in (N) NEUTRAL, move the neutral lock
lever to NEUTRAL LOCK position, engage the parking brake switch
and exit the vehicle using the hand holds.
7. Lift the quick attach lever. Insert the quick attach pin completely
through the attachment and the quick attach link. Be sure that the
quick attach lock lever has lowered and seated itself into the groove
in the quick attach pin.
8. Return to the cab, fasten the seat belt and resume operation.
WARNING:
DO NOT operate this vehicle unless you are in
the seat with the seat belt fastened around you. Death or serious
personal injury could result if the belt is not securely fastened.