SkyTrak 6042 Operation Manual - Manual (Page 172)

170 Model 6042 Origin 5/02
Test Procedures
Step 4:
a. Use your left foot to depress the service brake pedal.
b. Move the travel select lever to the (R) REVERSE position.
c. Ease your left foot partially off the service brake pedal make
sure that the Stabil-TRAK light remains ON.
d. With your right foot, increase the engine RPM slightly, as nec-
essary, just enough to back the vehicle off the block. While
backing off the block, the front left tire should remain off the
ground.
IMPORTANT! Perform procedures 5 through 9 with the engine rpm at idle.
Step 5:
a. Keep the service brake pedal depressed.
b. Move the travel select lever to the (N) NEUTRAL position.
c. Take your foot off the service brake pedal. The Stabil-TRAK
light should remain ON and the front left tire should remain off
the ground.
Step 6:
a. With the travel select lever in the (N) NEUTRAL position,
engage the parking brake switch.
b. Move the travel select lever to the (F) FORWARD position.
The Stabil-TRAK light should remain ON and the front left tire
should remain off the ground.
Step 7:
a. With the parking brake switch ON, move the travel select lever
to the (N) NEUTRAL position.
b. Lower the boom to exactly 45° .
c. Frame sway the vehicle no more than 5° to the left.
d. Frame sway the vehicle back to 0° .
e. Frame sway the vehicle no more than 5° to the right.
NOTE: Observe that frame sway will be slower than normal during this test.
f. The Stabil-TRAK light should remain ON and the front left tire
should remain off the ground. The front left tire should not raise
or lower during frame sway.
g. Frame sway back toward 0° , leaving the vehicle swayed to the
right approximately 1° to 2° .